e6000 Jewelry & Bead - Instructions for Use

INSTRUCTIONS

Follow these step-by-step directions when using E6000 Jewelry & Bead: 

Read directions and test small area before use.

  1. Surface should be clean, dry and free of dirt. For best results, lightly roughen surface before use.
  2. Puncture seal in neck of tube using pointer cap. Replace cap. Screw precision tip into top of tube cap. Replace with fresh tip as needed.
  3. Squeeze the tube from the bottom and roll up the tube as it empties.
  4. Ideal application temperature range is 10 to 32 ºC. However, fully cured adhesive can withstand temperatures from -40 to 82 ºC intermittently.
  5. Apply directly to surfaces to be bonded or repaired.
  6. Allow 24 hours for curing. Depending on materials and temperature, maximum bond strength may not be reached for up 48 to 72 hours.
  7. For future easy cap removal, apply a thin coat of petroleum jelly to the threads of the tube before replacing the cap.
  8. Clean uncured adhesive with acetone or citrus-based solvents. Cured material may be removed by cutting or scraping.

Note: May damage finished surfaces. Avoid such contact until completely dry. Not recommended for use on polystyrene, polyethylene, polypropylene, Styrofoam™ or paper products. Not recommended for any items that come into contact with food, drinking water or animals. Do not dry clean.